Painting 6-Panel Doors
Online
- Popeye_Card
- GRB's most intelligent & humble poster
- Posts: 31099
- Joined: April 17 06, 11:25 am
Re: Painting 6-Panel Doors
I concur with this rant. Multiplied by the fact that the doors are currently painted with green enamel, and I'm trying to paint them with white latex. After much experimenting with sanding, priming, spraying, etc. I have finally settled on stripping them with a heat gun down to bare wood, then re-painting. Ugh.
- Hungary Jack
- Mother Earth
- Posts: 19536
- Joined: July 24 06, 6:03 am
- Location: In Cognito
Re: Painting 6-Panel Doors
Ugh. Did you think about replacing them? I am assuming they are older (and probably of much better quality than the warped pine doors you get today) and original to your house. Otherwise, I cannot imagine the drudgery of that task.Popeye_Card wrote:I concur with this rant. Multiplied by the fact that the doors are currently painted with green enamel, and I'm trying to paint them with white latex. After much experimenting with sanding, priming, spraying, etc. I have finally settled on stripping them with a heat gun down to bare wood, then re-painting. Ugh.
Online
I finally went to the stripping method because all of the layers built-up was causing problems with getting the doors to shut very well without slamming them. Spraying them was OK, but during the winter it is a real hassle trying to do it in a detached garage and keeping it warm enough in there for the paint to cure properly. So I have been brushing them by hand, one at a time.
I love all of the old trim in my house, but eff the previous owners for painting it all green. The enamel is nice and smooth too, but it sucks for the folks who want to paint over it.
- Popeye_Card
- GRB's most intelligent & humble poster
- Posts: 31099
- Joined: April 17 06, 11:25 am
Re: Painting 6-Panel Doors
Old and original. Stripping them with the heat gun actually isn't that bad. Much better than doing it with chemical strippers, which I tried and was awful--took 3 applications to get all the layers off.Hungary Jack wrote:Ugh. Did you think about replacing them? I am assuming they are older (and probably of much better quality than the warped pine doors you get today) and original to your house. Otherwise, I cannot imagine the drudgery of that task.Popeye_Card wrote:I concur with this rant. Multiplied by the fact that the doors are currently painted with green enamel, and I'm trying to paint them with white latex. After much experimenting with sanding, priming, spraying, etc. I have finally settled on stripping them with a heat gun down to bare wood, then re-painting. Ugh.
I finally went to the stripping method because all of the layers built-up was causing problems with getting the doors to shut very well without slamming them. Spraying them was OK, but during the winter it is a real hassle trying to do it in a detached garage and keeping it warm enough in there for the paint to cure properly. So I have been brushing them by hand, one at a time.
I love all of the old trim in my house, but eff the previous owners for painting it all green. The enamel is nice and smooth too, but it sucks for the folks who want to paint over it.
- IMADreamer
- Has an anecdote about a townie he overheard.
- Posts: 12909
- Joined: December 6 10, 1:09 am
- Location: Illinois
Re: Painting 6-Panel Doors
Have you thought about spraying the doors?
-
Freed Roger
- Seeking a Zubaz seamstress
- Posts: 26073
- Joined: September 4 07, 1:48 pm
- Location: St. Louis
Re: Painting 6-Panel Doors
In the old barn I grew up in, we used those chemical paint strippers. I was fascinated by that bubbling goo and smell so I joined in. Probably explains all the "problem's" I have with proper use of quotes and apostrophe's, as well as there's and their's to.
But yeah, I have a couple old doors with the enamel that I've primed and painted over. Agree that it doesn't work too well. They always look like crap with paint chipping or peeling off, especially since they got kicked a lot by our elder little miss sunshine.
But yeah, I have a couple old doors with the enamel that I've primed and painted over. Agree that it doesn't work too well. They always look like crap with paint chipping or peeling off, especially since they got kicked a lot by our elder little miss sunshine.
- Hungary Jack
- Mother Earth
- Posts: 19536
- Joined: July 24 06, 6:03 am
- Location: In Cognito
Re: Painting 6-Panel Doors
I remember my dad using that chemical stuff. Good lord, he bought a big old house in Webster and proceeded to rehab the thing over 15+ years. The doors were big oak slabs painted with oil, and he probably went through enough thinner to strip a battleship. He also refinished all of the oak floors. Throw in laying down about 5,000 bricks, planting hundreds of shrubs, and the house was stunning when it was all done.
- JCShutout
- MacGyver of Underwear
- Posts: 13368
- Joined: April 18 06, 7:53 am
- Location: South City
Re: Painting 6-Panel Doors
Doors are so -4000s to 1963. Hanging beads are the way to go.
- Hudler
- All-Star
- Posts: 2293
- Joined: September 13 06, 12:02 am
- Location: Fulton,MO
Re: Painting 6-Panel Doors
JC has officially crossed the line to being a "damned dirty hippie!"JCShutout wrote:Doors are so -4000s to 1963. Hanging beads are the way to go.
- Hungary Jack
- Mother Earth
- Posts: 19536
- Joined: July 24 06, 6:03 am
- Location: In Cognito
Re: Painting 6-Panel Doors
Those beads have many uses.
-
Diddy
- Perennial All-Star
- Posts: 3583
- Joined: April 18 06, 7:45 pm
Re: Painting 6-Panel Doors
I'm in a similar predicament, current house is getting ready to be put on the market and the doors need repainted, they just need freshened up. Unfortunately the new homes doors all need striped and painted, so fun all around.



