Page 1 of 2
The blinking cursor of doom
Posted: November 10 11, 8:52 am
by heyzeus
I need the help of my GRB computer expert peeps.
So my desktop was grinding to a halt, then crashed. Had to have the hard drive replaced, and then it booted up fine. But only once.
Every time I try to boot it up now, I just get a dark screen with a blinking cursor. I can't even boot it in safe mode.
So I call my computer repair dude and he takes the computer back to check it out. He tells me it booted up fine for him, and the log shows no problems. He thinks the problem is one of the peripheral devices, so I should try booting up my computer after unplugging them one by one to see which is the problem.
I do that; each time, blinking cursor remains. Until the only thing plugged into the computer is the monitor and the power cable - and still, blinking cursor. So I take the monitor and, using the same cable, hook it up to a laptop. The monitor works fine.
So what the hell is the problem?
Re: The blinking cursor of doom
Posted: November 10 11, 9:41 am
by vinsanity
heyzeus wrote:So what the hell is the problem?
The IT guy?
Re: The blinking cursor of doom
Posted: November 10 11, 9:48 am
by heyzeus
Ok. With the computer?
Re: The blinking cursor of doom
Posted: November 10 11, 9:59 am
by docellis
I'd try connecting to a different monitor just to be absolutely sure and - try a different monitor cable...?
Re: The blinking cursor of doom
Posted: November 10 11, 10:53 am
by TheoSqua
heyzeus wrote:Ok. With the computer?
Have you tried connecting it to a different outlet/power strip?
If it were the hard drive your BIOS would boot up and yell at you for having a crappy hard drive.
If it were an essential computer component it would give you a beep code.
If it were a display issue you wouldn't see the cursor.
If it were a perephrial issue then you should be able to boot up without issue once it's removed.
The only perephirial that is essential to get passt BIOS bootup is the keyboard, so the only way it'd be a component is if the keyboard is somehow screwed up and the computer doesn't know how to relay it (Generally it would give a beepcode)
If it's not a perephrial then that means it's most likely a power issue. Either the power strip you have has gone bad, the electricity in your house hates you, or the power supply is starting to go out.
So my suggestion would be
1.) Try a different keyboard
2.) Try a new outlet
3.) Try a new power supply
if none of those work, go get a very large hammer (20lb+ sledge preferred) and set it next to the machine. In my experience all computers connected to Skynet will then immediately start functioning properly.
Re: The blinking cursor of doom
Posted: November 10 11, 11:05 am
by heyzeus
Thanks Theo, Vins, Doc. Looks like I'll have some things to try tonight (including the threat of physical violence on a machine).
Re: The blinking cursor of doom
Posted: November 10 11, 11:40 am
by wart57
Could be the flux capacitor...
Or the dilithium crystals.
Re: The blinking cursor of doom
Posted: November 10 11, 11:43 am
by Fat Strat
wart57 wrote:Could be the flux capacitor...
Or the dilithium crystals.
It's low on midi-chlorians.
Re: The blinking cursor of doom
Posted: November 10 11, 11:46 am
by Jocephus
Fat Strat wrote:wart57 wrote:Could be the flux capacitor...
Or the dilithium crystals.
It's low on midi-chlorians.
he doesn't have all the sankara stones
Re: The blinking cursor of doom
Posted: November 10 11, 12:04 pm
by sighyoung
Jocephus wrote:Fat Strat wrote:wart57 wrote:Could be the flux capacitor...
Or the dilithium crystals.
It's low on midi-chlorians.
he doesn't have all the sankara stones
Easy now. heyzeus can't change the laws of physics.